Im in the middle of setting up a policy to block all traffic outside of
the US. It appears I have to add each country to the Policy & Objects >
Addresses section separately and then create a group and add the
addresses to the group ...then create a p...
I have configured my VPN portal and have my RDP session working fine. I
have also tested our FortiClients and they seem to connect fine. My new
issue is how do I control which FortiClients connect? I would like to
only allow my clients to use their c...
I am new to the FrotiGate world and am hoping I can get a confirmation
that I have set up my FTP setting correctly. My FTP is set for the
default port of 21 and passive ports 11000-13000. I am trying to setup a
Cerberus FTP server and this is their r...
I just finished typing all these out by hand on my second and last
firewall. Just a bit too slow on getting your reply. Thanks. I will use
that for the next time I have to set this up.... which of course will
probably be never. :D Thanks again
I dont think that worked. I have the top most policy to US allow and the
second policy disabled with All and Deny and looking in the logs I can
see out of country traffic coming in at the time I implemented the
changes and continuing to come through.
Ok...I just have the second policy disabled because I didnt want to
enable it and accidently lock myself out... Nothing better than
struggling through CLI recovery on a Monday afternoon... I will keep
what is in place active and monitor the logs and ...
Tell me if this is correct... See attached screenshot I would think that
Traffic would come in from the US....hit policy ID 33....it is US
based...to it goes to next policy. Policy ID 31 then checks it and see
that it is traffic from the ANY group an...
