Hi,Currently I have my FortiClient VPN set up with IP addresses from a
range. This causes some issues with one specific application as
everytime when the clients set up a VPN session they get the first
available tunnel and IP address. The application...
Hi, I hope someone can help me as I am still struggling with Fortinet
Licensing structure.We have a fortigate 301e running 6.0.4.We tested
with the free 10 FortiClient that the Firewall comes with and all seemed
fine. Now we purchased a 50 License pa...
We have a business case to use 2 seperate Remote Access VPN
configurations on one Fortigate. We have a 50 FortiClient license for
our corporate laptops with full access to the network services. With the
current COVID 19 situation we are looking into ...
Hi, I am new to fortigate and just configured Remote access VPN for
FortiClient to our FortiGate cluster. I created Firewall rules for the
IP Address pool to the internal network, however some rules I like to
narrow down for specific VPN users. I Hav...
Hi, I am not going to paste the whole configuration, but your
configuration states PeerID Any. On the Fortigate side it's not the
localID, but the Peer ID you need to change: set peertype oneset peerid
"Noncorporate" It's in the Authentication sectio...
Correct. So I created 2 Remote Access VPN tunnels with the Wizard
(different IP range), then in the Authentication section of each you
define the PeerID that is accepted on this Tunnel. On the Client you
define the local ID for the tunnel it needs to...
Thanks, Unfortunately temporary disabling the other tunnel is not an
option with the current situation. Too many people using it on a daily
basis.Thing is that remote access never was a thing at our place, so
with he risk of closing the business and ...
As said, I have to VPN tunnel interfaces. Each with multiple users
concurrent.Just different PeerID.Works perfectly. I have at least 40
Users over the 2 tunnels.
Hi,I think this is the same config that I have. Each VPN tunnel needs a
PeerID in the Authentication settings:Accept types: Specific Peer IDPeer
ID: Whatever_name Then on the Client side in the Phase 1 local ID for
each Tunnel you want them to connec...