We are implementing a Fortinet infrastructure into one of our main
buildings. We are essentially building a new network for these users and
we are looking for this system to mesh well with our existing devices. I
am currently setting up a Fortigate 6...
I come from a Brocade environment where a traditional "stack" refers to
2 or more switches connected together via QSFP+ ports. All of our stacks
in other buildings are in the same IDF. You can control each switch and
its ports individually from the "...
Thanks for the response. The FortiGate definitely has a FortiLink
connection to FortiSwitch1 via Port 4 to Port 27. FortiSwitch1 is
displayed from the FortiGate in the "Managed FortiSwitch" section with
the a black circle and a FortiLink logo on/arou...
Been a day or so since I've last responded. My co-worker has been
helping me figure this setup out. Just an update of where I'm at... The
FortiGate has basic internet connectivity. We defined multiple VLANs on
the FortiLink port. For each VLAN we cre...
My apologies for not clarifying. The switches would all be on the same
subnet. The FortiLink connected to Switch1 will define the Subnet. .10
would be the SW1. SW2 would be .11 and would be connected to SW1. SW3
would be .12 and would be connected to...
Thanks for chiming in, everyone. Your information is very helpful. After
the original posting, I went back to check my configurations on the
FortiGate and I did find that I was trying to assign multiple ports with
the same IP range. My understanding ...
