Dear all, I am new here. Unfortunately I am not able to reply to any
post. I get the following error displayed:“An unexpected error occurred
and logged. Please try again later.” Any ideas?Thanks & regards,Prab :)
chad_lumbee wrote:Prab,were you able to retain the source ip of the
client with your design? it appears that the fortigate performs a NAT of
the traffic prior to utilizing the WCCP function, thus losing the source
ip of the client and thus prior to h...
Triggering a failover depends upon how you have configured the failover
in first place. Assuming that you have the default setup. The selection
is done in a sequence:Failed Monitored interfaces > Age >Device Priority
> Serial number There are followi...
Yes, I have tested this on 5.6.11 and 6.2.3 FortiOS version, I tested
with FGT-60E, the WSA was running 11.7 and 11.8 AsyncOS. The setup which
worked me is shown in the image below. Traffic flow:User Client ->
[internal6]FGT[DMZ] -> WSA -> [DMZ]FGT[W...
Chronis wrote:Hello all,Is there a need to assign IP addres to HA
interface(active/active) .?I have connect fg300 with Ethernet cable cat
6 and everything seems to be working fine , sync, restart one the other
continue....etcAnd one more question how...
hmiranda wrote:Hi all, Does any one know a command to show the
forwarding table (also known as mac address table) of a software switch
or hardware switch on a FortiGate? People reply to this question on
similar post with the get system arp but, as th...
