Hi there, I have FG60D with no license. since this product already end
of life support.I want to use this firewall as basic firewall with:1.
restrict user from certain port, that only can access internet to exact
address.2. use antivirus with install...
Hi there, kindly please help.I've created policy, with setting:- enable
NAT- enable web filter, with web filter's setting: - restrict youtube
access- enable fortigate category based filter using default setting. I
try to every computers, they can acc...
hello there, need help.we use fortigate FG60F with firmware 7.2.4there
are 2 ports as member on Fortilink.I want to change all members on
fortilink into manual mode.am I able to do that? I already remove 1 port
via GUI, and success. but I can't remov...
hello there.need help please.I've setup fortigate fg-60F.each port has
their own setting (act as interface).we have 2 internet provider. WAN1
is pppoe, WAN2 is dhcp from internet building.we've setup:1) int2 (port
no.2),have IP 1.0.0.10.netmask 255.2...
hello there,we use FG-60D, and one of ports connected to wifi router.
dhcp on wifi router has been disabled, and from fortigate connect to
port LAN on wifi router.setting on fortigate for this port: dhcp server
on, nat = enable, dns use same setting ...
hello thanks for sharing it.unfortunately still I can't do the same
way.when remove members, system not allowed to save the configuration,
need assign at least one member. I try to change switch mode to
interface mode, but get error. seems I need to ...
hello,noted on your comment. then if such as above,is there a way, I
remove members from hardware switch via GUI? because when I remove,
system require at least 1 interface connected
thanks dbu after we activate it, we found there is no member on
fortilink. I'm wonder and afraid, if use command:set
internal-switch-mode interfacewill all settings made for each interface
will be deleted/reset? or only 2 members that still on group
...
good question.am I missed to setting this one?any advice for setting
static route? as I described,wan1 -> pppoe. this connection have dynamic
ip public.wan2 -> dhcp from internet building management. another
questions, future we want to add another i...
hello..here tracert to gateway isp x.x.x.x from device under
int3:Tracing route to X.X.X.X over a maximum of 30 hops1 2 ms 1 ms 1 ms
1.0.1.102 2 ms 2 ms 1 ms X.X.X.X static route:only have entries for vpn
ipsec. update policy route, now only:source i...
