Hello guys, Following this vulnerability, Fortinet: Hardcoded
cryptographic key in the FortiGuard services communication protocol,
affecting FortiOS 6.0.8 and below mostly, my box is currently
"affected". In reality I dont use the feature, it is disa...
Dear all, I have a configuration on a FG where an aggregated interface
(ae1)is having several vlans associated with it, my internal and public
"zones" are established under this convention stating that "VLAN1" and
"VLAN2" are internal, while "Public"...
Hello, currently I just did a setup of tacacs+ on FortiGate 100D v5,2,5
build 701. After all this config, I put the command "source-ip" because
I wanted to use an internal address to make request for tacacs. But
after doing a test under the GUI for c...
Emnoc (Ken Felix): Thank you very much for your answer. Actually that
was a big doubt, because it was not so clear for me, how I should handle
this scenario, since all the examples I have looked so far are involving
physical/separated interfaces when...
Thanks in advance for all your help, mostly for the tip tat GUI test
does not take into consideration that you configured a source-ip, it is
not documented anywhere and thought it was a config problem or something
else. Best Regards,
Thank you very much for your reply! I did not explain correctly my
concern. The command you show me would show any generated traffic from
the source IP pointing the port, but I want to know if there is a way to
generate that traffic, like in the GUI ...
Actually yes I am using the diagnostic test command, but did not know it
would not use the defined source-ip. I do not know if there is a similar
way to show that traffic is generated from the declared source ip
command. Thank you very much for your ...
