Hello everyone, I'd like to better understand the "set
update-static-route" command and the effects of "enable" and "disable"
settings.I read several articles but I want to make sure what I'm doing
because I'm setting up a firewall remotely on a remo...
Hello! We just upgraded our FGT80F firewalls from 7.4.3 to 7.4.7 and
LDAP no longer works on the secondary units, it only works on the
primary units when trying to log on. We have to use the emergency local
account if we want to log in the secondary ...
Hello! I'm setting up override on my cluster and I saw this article:
Primary unit selection with override enabled | FortiGate / FortiOS 6.0.0
| Fortinet Document Library It says that we lose configuration changes
if the primary goes down, we do chang...
Hello again @dingjerry_FTNT ! I have a previous backup and it was
working perfectly on all four (4) firewalls, 2 per cluster. We were on
firmware FGT80F-7.4.3-FW-build2573-240201 Just wondering why it was
working before because it looks like a regres...
Hello @dingjerry_FTNT It fixed the issue and I didn't have to replicate
it on the secondary, it did it by itself. On the other hand, we are
wondering about possible side effects. We would like to only enable
ha-direct on LDAP requests. I found that w...
