How good has ARRP been in your experience? I know any form of auto
selection is generally viewed as bad but for a small branch office using
limited wifi, ('ve found it's generally "good enough" with other access
points I've used. When ARRP re-scans t...
I have a "Local LAN Zone" zone that does not have block intra-zone
traffic enabled. The only policy involving this zone is a basic
"internet out" policy for from "Local LAN Zone" to "wan1". In this this
zone is VLAN.2 interface which is assigned to a...
I've seen numerous references to AP's in tunnel mode being bound to the
FortiGate CPU for performance, but most of those posts also talked about
using a software switch. In my case, I have a FAP-221E connected to a
FSW which is connected to a FGT-60E...
60E on 6.0.4. I am using the FGT as DHCP server. The FGT itself has
timezone and offset (-5 hours Eastern) and reflects the correct time in
the dashboard. The DHCP server on the FGT is defined with "set
timezone-option specify" and "set timezone 12" ...
I' ve got 2 FG-90D' s connected over internet based IPsec site-to-site
VPN and am passing voice over the connection. Site A has an asterisk PBX
and Site B has handsets getting all their PSTN connectivity through Site
A. I' m new to FortiGate so I' m ...
I just got bit by this with a FortiGate on 6.0.5 and a 124E. The 124E
had 3.6.6 and was connected in FortiLink. I upgraded to 6.0.5 and the
FortiLink interface to the 124E (named "__FoRtI1LiNk0__") had dhcp
snooping set to untrusted. Did TAC say if t...
I've been back and forth with Fortinet support on this. It's been
definitely determined that when a FGT DHCP Server Time Zone option is
set to a time zone that observes DST, the DHCP Server will send the time
zone offset adjusted for DST in DHCP Opti...
ede_pfau wrote:just an idea...some DHCP options have to be specified in
hex. If you enter "12" is would mean 12hex = 18dec. But I haven't
checked this. DHCP option 2 is controlled by the DHCP advanced option of
"Time Zone" in the GUI, which lets you ...
Under Router / Static / Settings I have ECMP Load Balancing Method set
to Source IP Based. Under Router / Static / Settings / Dead Gateway
Detection I have two entries, one each for wan1 and wan2. They are both
dentical: Gateway IP - 0.0.0.0 Ping Ser...
