Hello everyone,I have a problem with the DHCP service no longer working
after reconfiguring fortinac using the configuration wizard.I tried to
restart it via cli but without success.Can you help me?
Hello everyone,I am working with FortiNAC-F 7.4 and I have imported a
Cisco Catalyst switch v3. The ports on the switch are in VLANs. I can
read them on the device, but the problem is that I cannot retrieve
certain endpoints on the ports. When I chec...
Hi Ebilcari, I found the error.The problem was that when I used the
ConfigWizard, it didn't write the IP of eth1 on port2. I manually
entered the ip on port2 and the dhcp service was able to restart.Thanks
!
Hi Ebllcari,The problem I'm having now is that I can't read the IPs of
the endpoints connected to the fortinac. The IP I see is only that of
the switch interface.Do you have any idea how to solve it ?
Hi AEK,sorry for my silence. I didn't have access to the switch
anymore.I've just tested the commands, I can see several devices whose
vlans have been added to the SNMP view (context vlan- match prefix not
working).I can't see the IP associated with ...
Hi AEK, below SNMP config: NB: the ports are in vlans other than the
default vlan.On the ports I've enabled: "snmp trap mac-notification
added" and "snmp trap mac-notification removed".
