Hi All, I've just configured link-monitor to allow failover to WAN2 when
internet access through WAN1 is unavailable.I've applied this config
without any errors, but it doesn't appear to display all the
settings.config system link-monitor (link-monit...
Hi All,I'm trying to configure a WAN2 failover but I'm getting stuck on
NAT.I have a primary leased line internet circuit on WAN1.I have a
secondary FTTC internet circuit on WAN2Both WAN interfaces are in a
WAN-ZONE.All firewall policies currently ha...
Hi All,I'm looking for advise on configuring a backup internet
connection using vDSL.I have a Draytek 167 which I plan to set to bridge
mode and perform the PPPoE authentication on the FortiGate.I have a
single /32 public ip address. Any thoughts on ...
Hi All, I'm in the process of migrating from a Sonicwall to a FortiGate
and I have come up against a NAT setting on the Sonicwall that I'm not
too sure how to recreate on the FortiGate. On the Sonicwall I have
several NAT policies that will do for ex...
@Toshi_Esumi spot on, thank you.FW1 # show full-configuration system
link-monitor config system link-monitor edit "WAN1_Failover" set
addr-mode ipv4 set srcintf "wan1" set server-config default set
server-type static set server "8.8.8.8" "4.2.2.1" se...
@Jirka1 Thanks for the reply.I did add the WAN2 IP Pool address into the
dynamic interface, but as I didn't specify the associated interface it
did not route. I will try adding the associated-interface parameter in
the next few days and report back.
I've just tested this and it
works.https://docs.fortinet.com/document/fortigate/6.2.15/cookbook/446182/virtual-ip-with-serviceshttps://community.fortinet.com/t5/FortiGate/Virtual-IP-with-services/ta-p/199427
Great stuff thanks.
