Hi all, who know how can i configure the interface type on my firewalls
(in ACTIVE STAND-BY) in order to implement a network failure in scenario
shonw below? Using Hardware switch after period the connection goes
down. I have to unplug the cable from...
Hi all, I need to know if it is possible to configure firewall in the
scenario attached. My scope it is to connect the router LAN and firewall
WAN and LAN on the same sub net as shown below in the screenshot. Let me
know which solution of if this is ...
Hi, I would like to know what is the best interface Mode to configure in
a scenario (see attachment) the ports 5 and 6.Firewall are 200D with
firmware 5.4.1 and configured with HA (ACTIVE and STANDBY) Thank's in
advanceBest Regards Arch
Hello, I would like to know if is it possible to configure on my
Fortigate 60D on Internal network 4 different LAN and allow all traffic
through these. 172.16.0.0/24 172.17.0.0/24 192.168.1.0/24 10.0.0.0/24
Thanks in advance Best Regards
Hi, I agree with you but unfortunately I don't have a couple of switches
to include.What about the best configuration Type coupled with Server
NIC Fault Tolerant: 802.3ad Aggregate, Redundant Interf, Software
Switch, Hardware Switch etc etc. I have t...
