Hello, I have a Fortigate 401F that I currently have access to via the
mgmt interface. This interface is connected to one of my core switches
(catalyst 9300) via cat6 and I can reach it at 10.Y.X.115/25. The
Fortigate and my switches are all in the s...
I swapped the SFP tranciever module from x3 and placed it into port 17
and both interfaces (port 17 on the Fortigate and the catalyst
interface) came up. This looks like it has solved the immediate issue.
Thank you for your assistance!
I will look into swapping out the 10Gbps module and try that out. If
that doesn't work, I'll dive into the CLI on the Fortigate.The
management port on the Fortigate does have Dedicated Management Port
selected. (the slider is green) the trusted Host ...
There is no STP info available on the Cisco for that interface. The
interface (Te1/1/2) is not in the blocked port list.The interface itself
is in trunk mode for the vlan that all of my switches live on (10.Y.X.0
/25).
The configuration on x3 is currently default. When I attempted to set an
IP(10.Y.X.31 /25) I was given the error message of "Conflicts with mgmt
subnet"All of my network devices live on the 10.Y.X.0 /25 network, so I
was under the impression that add...
On the Catalyst side we have a GLC-SX-MMD 1000BaseSX SFPon the Fortigate
side we have a FN-TRAN-SFP+SRthe catalyst interface:Speed: 1000Duplex:
fullx3 on the Fortigate:Port Speed: 10Gbps full duplexoptical cable is
multi modeI do not see a place in t...