Howdy, I just have a question on a firewall policy that I have been
playing around with. I have an IPSec tunnel between my agency and our
parent agency allowing traffic to 2 subnets on their end
(192.168.139.x). On my end, we have a supernet (172.19....
I am running the full version of FortiClient connecting to SSL VPN (with
EMS in between). As soon as I launch FortiClient and connect the RAM
usage will start steadily increasing until all 32GB are maxed out and my
laptop freezes. If I don't shutdown...
I have seen a few posts with the same title but nobody seems to have
found a solution yet. Has anyone found a working solution to the issue
where FortiClient will connect to VPN then immediately disconnect? We
are using FortiClient with EMS, and if t...
I believe this is the solution in addition to disabling NAT on the
incoming. I've set up the VIP and I'm able to ping between computers on
each end. I'm still having trouble with the application connecting but I
think that is an issue within the app ...
Sorry I didn't get to update the thread. It did seem like DTLS helped.
For the most part, users are able to connect without issue. On occasion
they'll run into this problem again, but if they just shut down the
FortiClient app and reopen it, they can...
Update, the vendor temporarily disabled the AV and no issues. So it is
an issue on the AV vendor's side, I just have to figure out why it's
only my PC and not everyone's, since we all use this product.
I'm waiting on the vendor to get back to me on if I can temp disable the
antivirus for testing (it is all managed through the MSP). I previously
used the free FortiClient app and had no problems, just for security
compliance we were moving to the ful...
