Created on 11-17-2022 10:28 AM Edited on 01-31-2024 03:52 AM By Jean-Philippe_P
Description |
This article describes that OSPF neighbor status keeps on changing in Init -> ExStart -> Full -> Init…
get router info ospf neighbor get router info ospf neighbor
get router info ospf neighbor
Init state: a Hello packet has recently been seen from the neighbor. However, bidirectional communication has not yet been established with the neighbor ExStart State: this is the first step in creating an adjacency between the two neighboring routers.
Full state: the normal operating state of OSPF that indicates everything is functioning normally.
IPsec VPN Tunnel_1 is up.
Packet sniffer for protocol 89, traffic is coming in, no reply.
di sniffer packet any "host 10.0.x.113 and ip proto 89" 4 Tunnel_1 in 10.0.x.113 -> 224.0.0.5: ip-proto-89 1400 (frag 25896:1400@0+)
From the FortiGate GUI, ping the remote 10.0.x.113, 100% packet loss. |
Scope |
FortiGate, all firmware. |
Solution |
VPN Tunnel_1 interface local IP 10.0.x.114/255.255.255.255 remote IP 10.0.x.113/255.255.255.255. Change the remote IP subnet mask to 255.255.255.252. |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.