Description
When there are no logs under router events, check it to monitor the interface status or route status when it goes down and comes up.
This article describes how to check this.
Solution
Go to Log and Report -> Events and from the top right corner select Router Events from drop down.
If there are no logs, the router event filter needs to be enabled.
To process it, use the following command:
When there are no logs under router events, check it to monitor the interface status or route status when it goes down and comes up.
This article describes how to check this.
Solution
Go to Log and Report -> Events and from the top right corner select Router Events from drop down.
If there are no logs, the router event filter needs to be enabled.
To process it, use the following command:
# config log eventfilter
set event enable
set system enable
set router enable
end
