Technical Tip: A command to check the beacon failure on the FortiAP CLI for a specific SSID

[vinodhk]

Description	This article describes how to use the command to check the beacon failure on the FortiAP CLI for specific SSIDs.
Scope	FortiAP, Beacon failure, SSID broadcast, Wireless troubleshooting.
Solution	Login to the Forti AP CLI. Execute the following command: apstats -v -i <wlan id> 'wlanid' can be identified from the following command output on the FortiAP CLI: iwconfig Example command output: The 'iwconfig' command output will be as follows: The 'apstats -v -i <wlan id>' command output will be as follows: Note: With fap-tech from the FortiAP CLI, wireless sniffer capture (OTA Capture) needs to be collected for additional troubleshooting.