Description This article outlines a step-by-step approach to diagnose
and resolve cases where a FortiGate or FortiProxy intermittently blocks
user access to websites. It covers common root causes, including policy
misconfiguration, LDAP inconsistenci...
Description This article provides a consolidated list of useful FortiOS
commands for verifying and troubleshooting a VXLAN deployment that uses
an EVPN-MP-BGP control plane. These commands allow an administrator to
check the BGP neighbor status, veri...
Description This article describes the issue of being unable to enable
the DHCP server in IPsec phase2 settings on a FortiGate and addresses
how to resolve this issue, which involves disabling the mode
configuration in phase1 settings. Scope FortiGat...
Description This article describes how to block intra-VLAN traffic at
the FortiSwitch level and force all traffic between devices in the same
VLAN to be routed through the FortiGate. This setup allows security
inspection, logging, and policy enforcem...
Description This article describes how to configure an IPsec VPN on a
FortiGate firewall using an IPv6 address as the gateway, while enabling
both IPv4 and IPv6 selectors for phase 2. Scope FortiGate. Solution
Configure Interface with IPv6 and IPv4: ...
You can refer to if you are also using Fortiauthenticator
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Setting-Up-Two-Factor-Authentication-2FA-for/ta-p/325709
Hi Obul, 1. Please check if phase 2 networks are configured correctly on
both end. 2. Check routes on both end 3. Check if firewall policies are
configured from and to between LAN and tunnel. Refer to the document for
config steps. Regards Manpreet S...