I have two sites broadcasting there available newtorks via bgp over a
site to site connection. When I do a firewall policy test the remote
system, it gives my default outbound policy vs the Firewall rules I have
already established. BGP Neighbors BGP...
I have an HA Firewall in a Active and Passive system. When the system
fails over the outbound WAN changes and I need to establish a vpn to the
same destination. What is the best solution for this?I see the cookbook
suggestion is SDwan
VPN.https://doc...
I have four standalone switch 1048E. I am in the process of implementing
to new fortigates. I am having an issue where the switch isnt passing
the vlan accross to the uplink port. This is the HA port for the
Fortigate pair. I have packet captured off...
I have been discussing if a Fortigate HA in A/P can work with BGP/EBGP
from a single ISP. So I wanted to see what exactly is possible. The ISP
was going to be providing the routing on their side with my firewalls
accepting the connection. I have put ...
I have having a switching/routing problem where the standalone
Fortiswitch thinks the MAC for the VRRP gateway is pointed to the wrong
port. I dont have a sticky turned on but I cant remove the address. MAC
Entries is empty. Copied config from port. ...
fgt # get router info routing-table allRouting table for VRF=0S*
0.0.0.0/0 [10/0] via 172, port1, [1/0]S 172 [10/0] via 172, port2,
[1/0]C 172 is directly connected, port1C 172 is directly connected,
port2B 192 [200/0] via 192 (recursive via 172, por...
fgt # get router info routing-table allCodes: K - kernel, C - connected,
S - static, R - RIP, B - BGPO - OSPF, IA - OSPF inter areaN1 - OSPF NSSA
external type 1, N2 - OSPF NSSA external type 2E1 - OSPF external type
1, E2 - OSPF external type 2i - I...
Basically I have a site to site connection and I am trying to leverage
BGP instead of static routing between the sites. I have BGP working and
each side can see the advertised routes but when I do a route lookup or
policy check the route isnt going t...
