I have an HA Firewall in a Active and Passive system. When the system
fails over the outbound WAN changes and I need to establish a vpn to the
same destination. What is the best solution for this?I see the cookbook
suggestion is SDwan
VPN.https://doc...
I have four standalone switch 1048E. I am in the process of implementing
to new fortigates. I am having an issue where the switch isnt passing
the vlan accross to the uplink port. This is the HA port for the
Fortigate pair. I have packet captured off...
I have been discussing if a Fortigate HA in A/P can work with BGP/EBGP
from a single ISP. So I wanted to see what exactly is possible. The ISP
was going to be providing the routing on their side with my firewalls
accepting the connection. I have put ...
I have having a switching/routing problem where the standalone
Fortiswitch thinks the MAC for the VRRP gateway is pointed to the wrong
port. I dont have a sticky turned on but I cant remove the address. MAC
Entries is empty. Copied config from port. ...
So I have the configured on different ports for the WAN failover. i.e.
Port 1 for Prod and Port 2 for DR. Is the exception allowing me to use
the same destination from 2 WAN ports. Is best practice to have the wan
ports ip on the same interface?
@Toshi_Esumi @Pittstate The firewalls will be geographically same city
but in different locations with a single drop to each location. The ISP
hasnt been real clear what the backend would look like other than a
single handoff at each location
