Hello all, I am currently setting up 802.x1 EAP-TLS authentication on an
external cloud radius server on my FortiSwitch 448E-POE (Fortilink) and
am experiencing a minor issue.Basically, I wanted to do this via TLS TCP
(RadSec).I noticed that the Fort...
Hello all, I have a problem where my two 448E switches are displayed as
“online” under Managed Forti Switches. I can also access the port
configuration and change it. So I guess the NTP is not the issue. NTP is
also activated for the fortilink interf...
Hi everyone,I'm currently working with the following setup:We have a
FortiGate 100FPort X1 on the FortiGate connects via 10G to a stack of 2x
Cisco CBS350X (on the Ground Floor).From there, there's an uplink via
10G to another stack of 2x Cisco CBS35...
Hello all, We use IPsec Dialup VPN with SAML via EntraID. When I try to
connect via IPsec VPN inside same network in which the Fortigate is
located, I get the error "ERR_EMPTY_RESPONSE" when calling SAMLIs this
an expected behavior? If not, what coul...
Hello everyone,I'm not sure if I'll get any help on this topic here, but
I'll give it a try anyway.We primarily use FortiClient VPN to establish
a VPN connection to our Fortigate via IPsec using SAML.Some employees
who do not work in the company, but...
Okay, I was able to resolve it.The correct interface is not
“_default.fortilink (_default)” but “fortilink”This was not visible in
the GUI, so I had to adjust the policy via CLI.
Hello @Markus_M We cannot use RADSEC (TLS TCP) since for my
understanding the FortiSwitch 7.6.2 not support Radius TLS via TCP yet.
Is this correct?Further I do not understand why there is no policy which
allows the traffic, since I created one polic...
@Markus_M The traffic should go via WAN1 because the RADIUS Server is
cloud based.The get router looks ok:FGT01 # get router info routing
details 209.xx.xxx.xxx Routing table for VRF=0 Routing entry for
0.0.0.0/0 Known via "static", distance 10, metr...
