What am I missing here ? My traffic is hitting my WAN address, but is
not hitting the LAN. First of all, this is on an old 90D that I am
playing with, so it's on it's highest release of 6.0.18I am trying to
hit a server inside my network from the out...
Hi all, I am adding an SDWan overlay onto remote sites, and so I had
hoped to build a secondary VPN ipsec tunnel and add to the SDWan zone,
and then shut the original tunnel and bring up the new. Both tunnels are
therefore using the same ISP, to the ...
Hi all,I have a Fortigate (7.4.4) with a discovered FortiExtender
(7.4.3) in WAN extension mode added to it. From the FortiExtender, I can
ping anywhere on the internet. I have a /30 link between it (Port1) and
the Fortigate (Port A), and I can ping ...
Hi all,I'm sure my issue is very small. Maybe I am just missing one
parameter from the Voice Profile ? The SIP Session is created perfectly,
and if the source of the Session is Inside on our LAN, we can make calls
in and out no problem.But if I clear...
Hi all,I have a VPN connection working between a Hub and a Spoke. I have
assigned IP addresses to the VPN interfaces, and I can ping each of them
locally, but I cannot ping each other across the VPN. I want to get BGP
peering working.Is there somethi...
Hi again,While I have got VIP from any IP working OK, I just cannot get
VIP with a specific SOURCE working. The source connects to a Public ISP
IP which port forwards All Ports to the WAN1 Ip address of 192.168.1.17.
The VIP Points this IP at 10.10.5...
This example if for a specific destination. What about when a specific
port is required ? Suppose I want to route all traffic for HTTPS
connectionsAs I see it, there are two optionsOption 1 - Tick the
Optional Filters and add HTTPS to Services, and i...
I actually created two rules, one for source specific IP to the VIP
object, and then a secondary rule from Any to Any over interfaces WAN1
to LAN. By messing about with things, I'm gradually getting hits.
While I could configure 2 x IPSEC Tunnels - one by IP and one by FQDN,
the FQDN one won't even try and connectDoes anyone know of another way
to REMOTELY configure SDWAN interfaces over an existing IPSEC VPN ?
