We are getting ready to switch over to VoIP and I have received a phone
to test with, before deploying the solution to our organization. If I
put a firewall policy in place to block all inbound traffic from the WAN
(internet) to our new VoIP subnet, ...
I have a question regarding the use of redundant interfaces. I am using
a single FortiGate 200B (standalone mode, no HA). I would like to
connect two different switches to the same interface on the FortiGate in
order to provide network redundancy in ...
We just purchased a FortiGate 200B and I can' t find any documentation
in the manual or on the website regarding uses for the 4 built in
FortiASCI NP2 powered ports. What are they, and when should I use them?
We are getting ready to roll out a new Vo...
I tried to apply the latest build (5.0.7) to our FortiGate 200B last
night. In the web admin console under System Administration it now shows
the following under Firmware Version: Firmware Version v5.0,build3608
(GA Patch 7) Which is great...... Howe...
Abel, Thank you for the response. I guess my confusion revolves around
incoming calls from the WAN (someone from the outside calling us). These
calls originate from outside of our network, but somehow can still get
to our phones inside the LAN when t...
Roman, Thank You for the link to the hardware manual, this is what I was
looking for. I don' t really need to perform any traffic shaping, so it
looks like I' ll just utilize the NP2 ports for everything.
Thanks, but I can' t seem to find any documentation or references at all
to the FortiASCI ports in any of those documents. One suggests referring
to a " Fortinet Hardware Guide" which doesn' t seem to exist. That' s
it, that is all I can find. Your s...
