Hello, there is an equipment that has Fortigate 200D 6.0.15 installed.
WAN1 (ISP1) WAN2 (ISP2) is connected to this equipment, and I want to
use these two alone without using load balancing. Example)WAN1 -> LAN1,
WAN2 -> LAN2The current Policy Route ...
Hello, thank you for your help. I wrote down the list below. RD-MG-IPSec
= Access VPN for ManagementREDREDGROUP-BO = Site-to-Site VPNshow vpn
ipsec phase1-interface config vpn ipsec phase1-interface edit
"RD-MG-IPSec" set type dynamic set interface "...
Thank you for your reply. :) If you set the Policy Route as shown in the
picture above, the Internet of WAN1 -> LAN1 + WAN2 -> LAN2 will be
connected normally, and all the policies you have forwarded will work.
However, it does not connect to a VPN t...
