Hi there!I would like to know if it’s possible to configure a Fortigate
80C v5.4 to use LDAP authentication to allow SSL VPN users to
authenticate to internal network only. When configuring SSL VPN tunnel,
users will not access remote desktop, VPN us...
I'm trying to configure IPsec VPN on a Fortigate 80C, and on a Cisco ASA
5505 firewall. Fortigate 80C is running v4.0, build0646, and Cisco ASA
5505 is running 8.2(5), with ASDM 7.12.I configured Site-to-Site on ASA
and assigned a peer IP address of ...
In addition, I have two laptops pinging continuously. When I putty into
FortiGate CLI, I see debug activity. It's saying authentication ok. I
attach screen shot.
The only policy I have configured are two policies consisting of source
to remote and source to local. I'll attach pic to show you. I was trying
to configure policy to allow IPsec traffic into & out, but I'm having
trouble creating new policy. It's a...
I have updated info.1. When I run "show isakmp sa" I receive
"MM_ACTIVE." According to this output, I do have connectivity between
two VPN endpoints. Phase 1 does come up. 2. When I run command show
ipsec sa, I receive message “There are no ipsec sas...
@Bubu, I created routed and policy based configuration on FortiGate
firewall. I attached pic. I created a route on ASA firewall. FortiGate
firewall already has P1 with IP settings you mention. I did notice error
message IPsec phase 1 error is no long...
