Does anyone have a working cleaned config of ADVPN in a Dual Hub setup
with BGP on Loopback and the spokes being full meshed to the Hubs? I
have everything setup and all tunnels are running, but when it comes to
the SDWAN SLA's the Hub1 is currently ...
Setup | Brand new pair of 601F's running in HA a-p mode. Running on
version 7.0.9 but also saw this issue on 7.0.7. Minimal straightforward
configuration - single root VDOM, etc. Issue | Seems to be triggered by
HA changes/reboots the secondary. All ...
Solution was to split the Hubs into 4 total overlays instead of 2. I
believe because the tunnels don't have IPs on them and everything is
sourced from a loop-back the hubs were getting confused when a spoke
wan1 and a spoke wan2 both arrived on hub w...
Those are for 7.4 which has the advpn 2.0 in it, they also go back to
utilizing ip addresses on the tunnels, vs sourcing from loopback, the
hub also only has 1 wan. My hub with 1 wan works fine, my hub with 2
wans is what is broken. I think I may hav...
Is there by chance an EMS server involved with this client? Follow up
question - on a fresh install of the client does it work until it
randomly doesn't/ you exit out of the client int he system tray.
FortiNet was able to figure this out in their lab: Problem Description:
The CPSS will hang, have high CPU usage and/or prevent proper bootup of
the platform if traffic is flowing due to the serdes passing traffic it
should not be passing. Workaround ...
Hey Graham, So I actually don't think anything is wrong with the direct
HA link. I think HA is triggering a bug in the system causing the
controller of the ports to error out. (sorry new to FortiNet so I don't
know all the components in a FortiGate y...
