Hi all, I would like to know if FortiSwitches can do Selective QinQ on a
normal trunk port, meaning: - if an incoming VLAN tagged frames has got
VLAN ID in the range 10-1100 it is forwarded being encapsulated with
S-tag S1; - if an incoming VLAN tagg...
Hi all, we are building a new infrastructure from scratch. Since it's a
green field installation we are open to any advice.I could provide you
with a bit of background and sure I will do if required. The environment
is that one of a building of three...
Hi folks, I'm struggling at defining trafic shaping policies and even
with a Fortinet engineer it seems harder and more difficult than
climbing the Everest mountain. In my case I want to limit at 600/150
DL/UL and I get variable results, meaning for ...
Hi all, I'm going to configure a FG 60E for a school. We would like to
take advantage of VDOMs (up to ten) because the firewall will serve also
other tenants I have to plan the network from scratch, firewall included
and unfortunately I don't have ph...
Well, I haven't got the confirmation but it seems that the feature might
be called IEEE 802.1X EAP pass-through as seen here
https://www.fortinet.com/content/dam/fortinet/assets/data-sheets/FortiSwitch_Secure_Access_Series.pdf
Does anybody have a pra...
Hi Toshi Esumi, thanks for your reply. I have just got the reply from
the Fortinet's engineer wit hthe proof that he was able to accuretely
limit the flows at 1Mbps, 2Mbps, 10Mbps and 20Mbps. I will carefully
review and compare his configuration with...
Well, sorry to pick up this old thread but eventually I managed to apply
many features. The Box is connected through LACP both in the internal
and the Internet-caììfacing interface, many VDOMs, on the external LACP
I'm using EMAC-VLAN, secondary publ...
Hi Ken, good point. Being the 60E in the lower part of the Fortinet
portfolio I had the same doubt but it seems it can be done unless I'm
missing something really obvious:
https://docs.fortinet.com/document/fortigate/6.2.0/new-features/226063/lacp-su...
