Hello All and thanks for the help in advance: I have two Fortgate
firewalls I have inherited and I am in need of some help. At the
head-end, I have a 90D and at the remote-end, I have a 90E. The IPSEC
tunnel had been created and I am trying to add in...
Found the issue. Everyone who posted was correct about Phase 2 missing
the network. The issue seemed to arise from the legacy config. I had
inherited this and it looks like it was created using the Wizard. Using
the Wizard you can only have one netwo...
FGT90E4Q17002511 # get router info routing-table all Codes: K - kernel,
C - connected, S - static, R - RIP, B - BGP O - OSPF, IA - OSPF inter
area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 -
OSPF external type 1, E2 - OSPF ext...
Just adding to this. config router static edit 1 set gateway
12.43.15.225 set device "wan2" next edit 2 set gateway 14.100.22.65 set
device "wan1" next edit 3 set dst 192.168.1.0 255.255.255.0 set device
"To_HQ" set comment "VPN: To_HQ (Created by VP...
The tunnel exists and works to and from 192.168.1.0 to 192.168.2.0. The
issue is adding the 192.168.20.0 route. The only option when creating a
static route is to tell the FortGate to send the traffic for
192.168.20.0 to the tunnel. I would think I n...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites