I have a throughput issue over my IPSEC VPN tunnel between our 200d
(5.2) and our 60E (5.6) firewalls. Site A.200D150mbps Up/D Site
B.60E100mbps Up/D I am having throughput issues when sending data from
site A LAN only to Site B. A single transfer is...
Is it possible to define a separate quarantine report schedule for
certain users who may want to receive the report more often than the
domain level schedule?
We have users with extra email aliases attached to their Microsoft
Exchange accounts. I had LDAP authentication profile selected with
Recipient Verification enabled and discovered due to a user complaint
that all of the emails destined to one of thes...
Fortimail 200E running v5.3,build 623,161019 I would like to enable
outbreak protection. When enabled I have noticed that a lot of good
email gets sent to the outbreak protection queue and sits there for 30
minutes. That is a very long time to wait f...
I am slowly migrating from a Barracuda 300 to the FortiMail 200E. I am
looking at the logs on the FortiMail 200E and noticed that all of the
inbound emails show the same client IP address which happens to be the
gateway address of the DMZ network in ...
The configuration is shown below. The IP addresses are fake/censored.
Site A Phase 1 edit "S****-M*****" set interface "wan2" set comments
"VPN: S****-M***** (Created by VPN wizard)" set remote-gw ***.***.*.***
set psksecret ENC
dmFyL2pt3NTmT2Iv97ct1...
After trying several query filters I still get the same 550 error when
sending an email to an alias. I have
tried:mailproxyAddresses=smtp:$mmember(&(objectClass=Group)(proxyAddresses=smtp:$m))subtreenever
Thanks for your reply. Yes my fortimail is setup in gateway mode in a
DMZ. I setup another LDAP profile using the suggested instructions. The
LDAP lookup passed using the alias but the recipient verification fails
and an NDR is sent.
We also just experienced this after getting a replacement 200D that came
with 5.2.9. The SSL VPN web & tunnel mode works only on WAN2. I have
attempted to unset the source-interface from the authorization rules as
indicated in other forums, however t...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
