Hey all, This could be a general question on FortiGate products, not
sure yet. I have a FortiGate 100E on 6.0.5. Configuring and testing a
WAN port.If I exec ping I get an expected response.But when I
exec ping 1.1.1.1 or exec traceroute 1.1.1.1 (or...
Found a solution? No. I know where SDWAN is, but am not prepared to put
it into production without understanding it further.One thing I have
found but haven't tested yet, is that on a WAN interface you can specify
'Secondary IP address'. Couldn't fin...
No, static routing.So, are we saying, that 'exec ping 1.1.1.1' would
return 127.0.0.1 (localhost) if the gateway is unreachable? And would
never state 'destination unreachable' or 'response timed out' ?
Any IP beyond the gateway causes this behaviour. I cannot get immediate
access to the device, so am unable to run your commands.However, I
checked routing (including using get router info routing-table) and I
didn't see anything abnormal. 0.0.0.0\0 w...
