I have a 100E device. On my public interface I'm receiving HTTPS request
which I'm virtually mapping to port TCP-8443 of an internal server but
it is not working. I have allowed this policy too. Please help.virtual
IP a.b.c.d --> 10.14.50.81 (TCP: 44...
I have a FortiGate 100e device in which I have taken out one LAN port
and set WAN role on it. I have assigned a /30 subnet IP address to the
port. The port is up and I can PING it from other zones. However, I
cannot PING the remote IP address of the ...
boneyard wrote: if you want to and have the time you could create a link
aggregate on the FortiGate, make port16 a member of it and see if that
gets a working situation. that does require removing the IP from port16,
removing the firewall policy and ...
10.11.50.0/24 is a known subnet and is connected to the LAN subnet
through an L3 switch. I don't know how those broadcasts are reaching my
LAN port. # show | grep -f port16 config system interface edit "port16"
<--- set vdom "root" set ip x.y.z.189 2...
No, I haven't configured port16 as member of any aggregate. I can't do
anything about the ISP end config but given that it works on laptop it
shouldn't be an issue.After testing various configurations I always
revert to the default/standard state.I f...
Yes I'm connecting the same cable and assigning the same IP
(x.y.z.189/30) manually on the FGT-100E and laptop. The LAN port members
were port1 to port16 initially. I took out port15 and port16 to assign
WAN role. edit "lan" set vdom "root" set ip 10...
'get sys arp' is not showing the port in question. I ran 'diag sniff
packet 4' which is only showing arp requests. No arp replies. But
when I connect the cable to a laptop it works. Btw, this is an Internet
link with publicly available IP. Is there ...
