I have replaced the FortiAP 221c from Fortigate 100F to fortigate 80E. I
was connected on 100F but when i connect the same AP to 80E it is
showing as discovery AC and stuck in connecting mode. I am able to
connect reach the device and able to https a...
Hi, i have 4FortiAP 221C with OS as FP221C-v6.0-build0044 connected to
Fortigate firewall 100F. Currently we are facing problem on wifi
connectivity like we observed the randomly all AP channel utilization
increased on both 2.4 and 5ghz. we have set ...
I tried that also but still no success and on Fortigate firewall side
NTP is configured properly show full system ntconfig system ntpset
ntpsync enableset type fortiguardset syncinterval 30set source-ip
0.0.0.0set source-ip6 ::set server-mode enables...
Hi @ebilcari i tried that part also but unfortunately it didn't work is
anything related to date and Time for that i tried below command but
that also didn't work neither the date and Time changed on AP. Also,
Radio 1 and Radio 2 are in disabled mode...
Hi @ebilcari , I tried the same command but there is no improvement on
this. still the AP is showing as offline mode only. kindly suggest
furtherForti OS 80E - v7.0.15 build0632 (Mature)Forti AP - 6.0.6
Hi @adambomb1219 ,can we have any free solution where we can find what
is exact no's of the AP is required on my office network so that no once
face any issue with the low signal issue.
Hi, @anignan we have 20 MHz for 2.4Ghz but still the interfering SSID's
are there and some of the SSID are not our network . Please find the
attached SS. is any free software to perform the site survey to check
how many AP is required and where we ne...
