Description This article describes the cause and resolution for the
error 'Cannot reassign primary private IP addresses' seen in the OCID
debug output during Oracle Cloud Infrastructure (OCI) FortiGate HA
failover. Scope FortiGate, OCI Solution In OC...
Description The article describes how to export the filtered packets in
the Wireshark to a new file. Sometimes, Wireshark files can have many
packets that are not of interest and filters are applied to display the
packets required for troubleshooting...
Description FortiOS supports multi-hop BFD from firmware 7.2 onwards.
This article shows the multi-hop BGP configuration on Fortigate. Earlier
BFD was supported for peers directly connected on same network. Not to
be confused with BGP multi-hop, that...
Description This article describes how an offset list is used to alter
the metric of the routing protocols. RIP uses hop-count as the metric
and an offset list can increase the hop count (metric). Scope FortiGate,
RIP. Solution By default, the FG...
Description This article describes that some multicast applications set
the TTL value too low or even 1 to limit the propagation of Muticast
traffic within the LAN. TTL should be sufficient to cover the entire
multicast domain. Scope FortiOS Multicas...
Hello, If I understand correctly, you want to use both SAML and cert
based auth for separate SSL VPN users. You can map different portals to
the authentication rule under SSL VPN settings. Portal_1 : SAML Portal_2
: cert based Thanks Please upvote an...
Hello, The network ID is a Fortinet-proprietary attribute that is used
to select the correct phase 1 between IPsec peers, so that multiple
IKEv2 tunnels can be established between the same local/remote gateway
pairs. So it may not be available in Cis...