Hi,I am confused if how traffic shaping values work in fortigate. Say if
we have 1 MB pipe of internet what should be the value in shaper. 1024
or 1024x8=8192. Regards,Sushil
Hello,I require to capture the traffic on wireshark.More or less the way
if using SPAN port on Cisco switch.So found if sflow can be used on
Fortigate as I do not have any managed switch in our network. Configured
and sflow collector ip as the wiresh...
I would suggest you to configure the route based VPN.Create a IPSEC
policy for each ISP (assuming remote site also having two ISP) and play
with routing. If Peer side VPN device has just one ISP then configure
your Fortigate device as backup IPSEC in...
Hi,Does this happening with all the applications. Simply try nslookup
and see if you getting any fqdn associated with that.If not then
this is correct behaviour. Regards,Sushil
The config is as belowconfig system sflow set collector-ip 192.168.1.78
set collector-port 6343 endand internal gatewayconfig sys interface edit
internal set sflow-sampler enable set sample-rate 512 set
sample-direction both set polling-interval 30 n...
