Re: Doubt about DSCP value

GDiFi · 06-28-2022

If you do: set traffic-priority DSCPset traffic-priority-level high this will prioritize all traffic as high. You will want to set that as the default medium or change it to low. You can then set matching DSCP values to priority queues based on this:...

GDiFi · 06-28-2022

I am also running 7.0.6 with a few FortiSwitches and FortiAPs and have not see any issues with that process yet. Was there a specific bug ID or cause for the CPU spike in that process that was referenced in your TAC case?

GDiFi · 06-28-2022

Hi Mike300, Since you have an all-in-one modem from your ISP, this would need to act as the WAN connection to your Fortigate, and you can create new networks behind that. If you are trying to make the Fortigate the main router for your home, you will...

GDiFi · 06-28-2022

Hi JakeBlues, The Fortilink IP address is only used for management between the Fortigate and the Fortiswtich. The actual ports on the fortiswitch will be configured for different vlans than the Fortilink. These vlans, however, will need to be differe...

GDiFi · 06-28-2022

You can verify the DSCP values are staying on egress by doing a packet capture on the ingress and egress interfaces and check the packet header on both to make sure they stay the same. As far as prioritizing the traffic in the Fortigate, the Traffic ...

User Statistics

User Activity