About rphulekar

rphulekar · 10-26-2015

Description This article discusses the maximum number of OSPF neighbors allowed in FortiOS. Solution The limit of a maximum number of 10 per VDOM, which is as stated in the Maximum Value table for version 4.3, 5.0.x, 5.2.x is restricted only to the s...

rphulekar · 07-01-2015

Description This article describes that in FortiGate, to set status disable under ospf-interface will only prevent the parameters defined here for the OSPF interface from being used. It will not disable an OSPF interface and bring down the OSPF. Solu...

rphulekar · 06-18-2015

Description In FortiOS v5.2.x and 5.0.x, policy based IPSec is disabled only in GUI by default. It can be configured in CLI or by using the Enable feature in the GUI. Once enabled, IPSec tunnels can be used in the Firewall Policy. Solution To enable ...

rphulekar · 06-03-2015

Description In FortiOS 4.3.x, the CAPWAP was enabled by default on all physical and VLAN interfaces. In most cases a FortiAP is only connected to the internal interfaces to create a private WiFI network inside the network.However, this can be a poten...

rphulekar · 04-27-2015

DescriptionIn the version 5.0.x and 4.3.x there were 2 Firewall polices, one standard from WAN interface to the internal interface with action = sslvpn and the second one is ssl.root to the internal interface.In the version 5.2.x, the firewall policy...

User Statistics

User Activity

Technical Tip: Maximum number of OSPF neighbors

Technical Tip: Disable OSPF interface does not bring down the OSPF adjacency

Technical Note: Using policy based IPSec in version 5.0 and 5.2

Technical Note: FortiAP is detected by the FortiGate Controller but is not Authorized

Technical Note: SSLVPN policy no longer seen after upgrade to 5.2.x

KCS