I was cleaning out my junk box this weekend and I realized I have an old
FortiAnalyzer 100C. Everything works and it's been upgraded to the
latest FortiOS code available. Unfortunately, I'm running a Forgate 61E
running a later version of code so the...
I'm helping a customer migrate from a Cisco router w/ACL legacy security
solution to a FTG w/UTM solution. They would like me to do a little
discovery before the migration so they have configured a FTG 60D
(unlicensed) in one-arm sniffer mode monitor...
I have a similar request from my customer as well. You want the firewall
to include the "X-Forward-For" header information, which is the original
requester IP address. After doing some digging it doesn't appear there
is a way to include that info by ...
Everything looks good on the Fortigate. If you can take a screen shot of
the route-table(s) on the Azure side that would work. It could be your
not propagating the routes to the vNET from the VNG. By default, the VNG
will route RFC1918 back down the ...
I have an old FAZ 100C and asked a similar question a few months ago and
have not gotten an answer from anyone on the forum. I know you can set
the FAZ up to just receive syslog from network devices but other than
viewing the raw logs you can't do an...
