Hi, Is it possible to execute the backup automatically with the variable
"hostname" as backupname.cfg ? I need to backup a lot off Fortigate to
the same destination, so i need a different name for the backup file. I
can do this manually, but i want t...
Hi, I have setup a VPN between Fortigate and Azure, but no traffic is
going out through the tunnel. Have someone successfully installed and
configured a VPN between Azure and Fortigate, with traffic over the
tunnel ? Kind Regards,
Hi,We have a Fortigate 40C, and 8 X 25D Access points. We thought that
this Fortigate have a max of 10 Access points, but the problem is that
this is only when we use the AP's in bridge mode. We want also configure
the Tunnel mode, and then we can on...
Hello, I have two Fortigates 200A in HA mode Active Passive. The Passive
Fortigate is connected with one cable to the Active Fortigate. We use
the second fortigate only as backup for the Active Fortigate. The
problem is when we want to upgrade these ...
Hello, Thanks for the reply, we upgrade the firewalls without any
problems. We use the following setting, config system ha set
uninterruptable-upgrade disable end and then both Fortigates will be
upgrade with the new firmware. Regards,
Hello, When we use the following setting; config system ha set
uninterruptable-upgrade disable end both fortigates in Active-Passive
mode will be upgrade at the same time ?, and i have no problems ? Kind
regrads
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
