Hi all, I tried to set up a FortiAP 14C for the first time and have some
questions. One of our customers wants to connect a few branches with the
HQ, using FortiAP 14C on the remote side and a FortiGate 40C in the HQ.
Each FortiAP should connect devi...
Many thanks for your assistance, enabling CAPWAP on WAN1 was the
solution. The APs now connect with the 40C in the HQ. Unfortunately I've
another problem now: Using a Win7-based PC connected to one of the APs
works fine: I could surf the web as well ...
To enable DTLS in the AP profile, it's not necessary to connect the AP
directly to the FortiGate? That could be done later, even when it'll be
installed in the remote location already, right?
Will CAPWAP enabled really affect the tunnels? There are four defined on
WAN1: Two are tunnels with Netgear devices on the other sides, one is
for mobile users using FortiClient. Two of them use CAPWAP already.
Here's a screenshot with the current co...
I configured the public IP address of the 40C as "AC IP Address 1" in
the 14Cs. The WAN1 interface of the 40C is not enabled for CAPWAP in
general yet. It's enabled for two VPN tunnels bound to WAN1, but not on
the interface itself. Can I do that wit...
Hi ede_pfau, for sure there are DSL routers at the branches, the usual
German stuff (I saw you're from Heidelberg :-)) like Easybox, Fritz!Box
and Speedports. I assume my problems are based within the configuration
itself. Do you know a good source o...
