I can use the CLI to reserve an IP address for a particular
computer/device but how do I get a listing of what has been reserved? I
cannot find anything in the manuals that discusses how to view all
reserved IP addresses. Thanks in advance, GregH
Ok, I am new to the Fortinet series of FW and I just installed a 60C. It
has been a challenge and I have a few questions. 1. I am trying to
switch to the Interface Mode that will allow me to assign individual
subnets to each port. I have reset the 60...
Sorry about the delay. I have port 1 of the 60C going to the external
NIC card in the UT box and the internal NIC in the untangle box going to
the port 1 of my switch where the other comuters are connected in. I do
not think that the subnet address o...
I have this currently running on my home system with a 60C and
everything is running correctly and there is no system degradation. Go
to the Untangle site and then look up the " configuration options" and
use the bridge mode. I have set up the 60C wi...
Bob, Thank you very much for your post. As it turns out I discovered
this last night and got the FW working with just the changes that you
said to do. Critical oversight on my part. I have all of my interfaces
configured now and it appears that all c...
Found it, Google. This is driving me crazy. I have no sophisticated
setup and right now all that I want to do is to access the internet. The
WAN1 network is set to DHCP and is getting the correct information and
the DNS server addresses. I have the r...
