Hello, About 18 months ago, we upgraded the school network, I insisted
that we had Fortinet in to run our web filtering and firewall, but our
IT guy (long gone) had to have a microtik router to manage the network
and wireless AP, I don't know why, bu...
Hello, About 18 months ago, we upgraded the school network, I insisted
that we had Fortinet in to run our web filtering and firewall, but our
IT guy (long gone) had to have a microtik router to manage the network
and wireless AP, I don't know why, bu...
Hello I tried to configure a 200E to un in transparent mode tonight. I
set the internal IP, netmask and gateway. Through CLI. Now I can't
access the set IP, ping the device or access through the management
port. I'm basically trying to stick it in tr...
I think one issue we may have is that we have a 200E but have more than
200 users. I shall speak with my IT guy tomorrow. See how they are
progressing. Mikrotik is managing the network and WiFi fine, just not
filtering or monitoring sites. The cost.o...
Thanks for the response, We have one fixed IP address on a leased line,
100M and a 1Gigabit not fixed IP. Mikrotik is currently load balancing
using these two linesLigowave AP throughout the school - 26 or so in
total Topography wise what would need ...
Got it eventually. Not sure why but a couple of goes at HTTPS it worked.
Any advice on how to get it to run in transparent mode. Current setup is
ISP--->Mikrotik router (cloud something) -->ciscomanaged switches x
12There are a couple of VLANS setup ...
I used -> config system settings -> set opmode transparent -> set
manageip 10.10.10.23 255.255.255.0 -> set gateway 10.10.10.1 -> end
10.10.10.1 is the Mikrotek router for the site .2-.22 are all cisco
switches, .23 had nothing assigned seemed a good...
