I am in the process of switching over from one ISP circuit to another. I
have a /28 on an existing circuit I have a /29 and a /28 on the new
circuit, I had the carrier route both the new /29 and /28 to the same
gateway. What I would like to do, is pu...
Hi, Trying add to a list of routing addresses to our SSL VPN, and the
GUI complains 'invalid input'. I have 6 subnets listed, and need to add
a 7th. Is there some limit or strange 'special' character issue? My
address names look like this...
10.20.0....
I keep getting people who are obsessed with click-bait sites, and it's
getting near impossible to block them all. Many seem to come from Akamai
hosted sites. As an example, it seems the site www.thedailywheel.com is
hosted at Akamai. How can I block ...
Hi All, I've read the existing posts and reviewed the cookbook
videos...but I haven't seen a good example of our configuration. We have
two 100Ds in HA in two different buildings. Each location has a separate
ISP (Level3 in one building and ATT in th...
Hi, I'm trying to understand how to replace an Cisco ASA with a
Fortigate 100D running 5.0. Our core swtiches route all 169.212.x.x
traffic to the 169.212.1.1 interface on an ASA via a trunk allowing vlan
212 traffic. 169.212.1.1 is the gateway for a...
Answered one of my questions...the 3 entries in the routing table were
due to the fact that I added 2 addtional IP address to the interface (3
total...make sense) to test. I took the 2 secondaries out, and the
routing table behaves properly - only on...
Assuming I have to run additional connections between buildings, would
this be the best way to connect the devices in order to use Wan Link
Load Balancing? ron
I made a mistake in typing the address above...we route to the physical
lan interface (169.210.1.1) on the ASA, then flow traffic to the 169.212
network via rules. The ASA has another physical 169.212.1.1 interface
trunked back to a Cisco switch whic...
