Hi I have configured a zone with two IPSec tunnels as its member. Both
tunnels route traffic to the same remote FTG, one via an expensive link
and the other via ADSL. I would like to apply different traffic
prioritisation profiles to traffic in each ...
Hi I am struggling to get inbound NAT via the second (non default GW)
WAN working. When I change the default GW to be on the 2nd WAN network
my Virtual IP NAT policy works, when the default GW is on WAN1, it does
not. We have tried to configure a pol...
Thanks for the great tips Ede and Nothingel. I have defined outbandwidth
- but I suspect that this is something that is easy to miss, not much is
made of it in the documentation, it is treated as an optional step.
Nothingel, the devices on my LAN doe...
The problem with using static routes is that my requirement is for
inter-branch traffic. So, there are two static routes between CPT and
JNB - one via the " BL" VPN and the other via the " DSL" VPN. The DSL
VPN has a a higher weight than the BL VPN. ...
Hi Bob Thanks for taking the time posting so much details. I am afraid
that I still do not see how this will help me prioritise traffic on a
specific IPSec VPN different from a different VPN - when both VPN
interfaces are part of a zone. Emnoc, I agr...
I have about 14 policies, so if I have to double them up it would be not
too many. But it does complexity for support over the next few years.
Bob, are you saying you setup Virtual IPs and used these in firewall
policies? I assume one VIP uses on VPN...
