Hello, I've been trying to use snmptranslate in linux but I keep getting
errors. I need to be able to get a complete list of OID's for use in
snmp monitoring for any fortigate device. I'm not sure if Fortigate uses
the same mib for everything or if e...
Hello, I want to make 5060 and some other ports for sip prioritized over
my other firewall policy rules. What's the best way to do this? Would I
make a lan to wan rule, put it as the top policy and select the
services? Would that affect both incoming...
Hello, What's the best way to prioritize all traffic on 5060? Softphone
traffic goes over that so it's critical that regular internet traffic
(softphones are run on the computers that are on the data vlan) doesn't
impede upon it. Ideally the way it w...
Hello, I have weighted round-robin set to 100% weight on wan2, and wan1
has 0%. However, some traffic still goes out over wan1. The issue is
that we have a voice system and the ip that the phones are registered on
has to be the same wan ip that it us...
This list seems to omit a lot of OID's though like cpu usage, memory
usage, etc. So, maybe I'm still not doing it right. Getting lots of
these errors too: Cannot adopt OID in FORTINET-FORTIGATE-MIB:
fgVpnTunEntry ::= { fgVpnTunTable 1 } Cannot adopt ...
I did get the OID's. I had the syntax wrong for smtptranslate. I forgot
the ./ in front of the mib file. ubuntu:~/Desktop$ snmptranslate -Tz -m
./FORTINET-FORTIGATE-MIB.mib "org" "1.3" "dod" "1.3.6" "internet"
"1.3.6.1" "directory" "1.3.6.1.1" "mgmt"...
Oh that's right, I think traffic shapers are shared by default, so if
you create one shaper and apply to different policies, it works for all
of them. Thanks!
emilec wrote:Rules are processed top down. So specific rules at the top,
less specific or catchall rules below. Oh ok thanks. Also, I have a
wireless vlan as well. Can I just add that to the catch-all rule? I want
that plus the data vlan to be limite...
Hello, Don't I have to make the other policies specific as well? Like
normally I would put the service as 'all.' However, if I specify a
separate voip policy for certain ports, won't I have to specify the data
policy as all the other ports not includ...
