Hello,I have fortigate 1000C, I have configured before the logs to both
the disk and also to forticloud.Now I have purchased and enabled logs to
FortiAnalyzer also.I see due to CPU & memory utilization, I have
disabled logs to disk since I have now F...
Hello,I have a fortigate unit with firmware v5.4.2,build110, and I have
two wan interfaces with too many inside interfaces. I have a policies
identical and duplicated and I want decrease this HUGE number of
policies by creating a zone for the WAN int...
hello, I have two fortigare 1000c units, and i’m in process to have teo
internet links from the same isp and i want to apply BGP, and i have the
following questions: 1- i will receive the default route from the isp
through the two lines but i need to...
Hello,i have two fortigate 1000C units with failover configuration.i
have two internet connections from two ISPs without BGP config., and i
have configured WAN load balancing (WAN1 for ISP1 and WAN2 for ISP2) and
it is working.Now, i will remove the ...
Hello,I have configured remote access VPN using IPsec and SSL
successfully, now how can I grant special access per user?for example,
for userA only telnet is allowed for destination 172.16.50.1and for
userB only FTP is allowed...... Thanks in advance
Thank you.regarding the WAN load balance, I need to disable before
applying BGP since there is no advantage to use in this case,
right?regarding the IPsec tunnel, I think I can use a loopback to
terminate IPsec tunnel, right? thanks
Hello and thank you for your help.the problem is solved, i was trying to
telnet x.x.x.x 25 from two of my local ISPs and they blocked this port,
so, i tried to use online telnet tool from the internet to x.x.x.x 25
and is succeeded. I have another qu...
