Description This article describes pre-requisites needed for the log
parser feature to be visible. Scope FortiAnalyzer. Solution This article
talks about the steps to check on FortiAnalyzer in case Log parser TAB
is not seen under Incidents & Events ...
Description This article describes the configuration when both
FortiGate-VM and FortiManager-VM have no internet access (air-gap).
FGT-VM (no internet access)----FMG-VM (no internet access). Scope For
FortiGate and FortiManager-VM and hardware device...
DescriptionThis article dicusses how to import a signed Certificate from
a Third-Party vendor onto a FortiGate.Solution1) You can get a signed
Certificate from a Third-Party CA and Import it into the Local
Certificate Store in a FortiGate and apply f...
Description This article describes how to enable IPOA connection type on
ADSL on a FortiGate used over ATM. Scope FortiGate ADSL devices.
Solution This is an explanation of different connection types used for
ADSL units connection over ATM:PPPoA.The ...
Description This article explains how to connect to an IPSec VPN tunnel
from a DOS prompt. All commands must by run as the Administrator. In a
DOS prompt window, under the default installation folder of FortiClient
(C:\Program Files (x86)\Fortinet\Fo...
Hello,Firstly having IP on two interfaces which are in same network ID
is not suggested practice so it is strongly suggested to change IP
either on MGMT or internal portIt is not allowed unless subnet over lap
is enabledAnd as for why it started work...
Hello,"ignoring ike request, no policy configured" usually suggests
firewall policy missing for Virtual IPSEC interface.You might want to
cross check firewall policies on Fortigate, there should be following
two polices configured:1>IPSEC virtual int...