Hello!I have a issue with fortigate 800c. It keeps dropping packets on
high bandwidth load. Lets say I ping a 10.2.2.X server from 10.2.2.X
server with 54 bytes, I lose around 5 packets in 30 seconds. When I
increase the packet size to 65000 it loses...
Hello!I'm moving from Juniper to Fortigate and I'm having issues setting
up subinterfaces.I have setup a port 3 VLAN subinterface with VLAN tag
704 (port 3 IP is 0.0.0.0/0.0.0.0): edit "port3" set vdom "root" set
type physical set snmp-index 7 edit "...
emnoc wrote:I would start by looking at port errors. Sounds like duplex
mismatch I like a few important things to look at in the below output
but any errors or collision, is a good indicator of duplex mis-matches
from the diag hardware dev nic < nicn...
Hello! I got it working. My bad on the ping side from MacBook to
Fortigate. I did not use the right source address for ping and now
everything works. The problem was I was first pinging from non VLAN
interface, once I changed to VLAN source everythin...
emnoc wrote:I think your not understand vlan tagging, 1: do yo have a
switch between the port3 and pc 2: is the switch configured for the
vlan(S) that matches the fortigate subinterfaces 3: is the PC/host in
the correct vlan-id 4: if you have a switc...
vjoshi wrote:I am sorry, I am not sure about your requirement.- But the
current configuration looks to be fine and you should be able to ping
the Fortigate(10.2.4.1) from those 2 machines :Comp 1: 10.2.4.22 Comp 2:
10.2.4.24- Firewall policy doesn't ...
vjoshi wrote: Hello, A VLAN interface is attached to a physical
interface. When the FortiGate sends out traffic to the physical
interface level, the egress packets are untagged, whereas the packets
sent on a VLAN level are tagged. If on a particular ...