Hi everyone.New to the forum and (partially) new to Fortigate firewalls.
We have a Fortigate 100e (6.0.4) with a hardware switch running 6 vlans,
one being 10.21.50.1. This is going to replace (at some point) a Cisco
ASA. However, for the time being ...
No laughter here. I too am a Network Engineer and have had my fair share
of "oh no" what is this scenarios. Sometimes the solution is sitting
right there, just not yet readily viewable.
One way is to setup two VIP's within the Fortigate. Map your public IP's
to your private IP's for both internal systems (RDP and your on-prem
EXCH). Afterwards, configure your IPv4 Policies to allow traffic only on
the specific ports/services you nee...
Hi mcdaniels, Just curious as to what types of ("buggy") issues your are
experiencing. We have a 100D running 6.2.2 and haven't noticed any
problems. There is the occasional CLI drop-out, but that's about it. W_k
emnoc, The procedure you posted describes importing the cert to a
windows server. My requirement is to export/import to another Fortigate
100e. Is the process still the same? Thank you, W_k
