Can you post the debug output from dhcpd (on boot and when a discover
comes in)? Can you do a " diagnose sniffer packet any " port 67 or port
68 or arp" 4" ? Perhaps the server is sending the response somewhere it
shouldn' t?
The warning you mentioned seems to suggest that the HA sync of your DHCP
leases is failing. I can' t say I know too much about HA, so I' m not
100% sure why this synchronization is failing. What does the dhcpd say
when you get a discover from a clien...
How do you have the DHCP server configured? Do you have DHCP over IPSec
enabled on the phase2 of the tunnel? In MR6 there were some major
changes under the hood of IPSec, so I think your problem probably lies
with the ipsec configuration. Also, diag ...
There is one way, but it' s a diagnostic command, so it' s not supported
and may be a little tricky. Basically you go: diagnose sys checkused
. So for
example if I wanted to check where an interface named " test_intf" was
used I would type in: diag ...
Unfortunately there' s no listing that I know of. You have to hope there
is a quick error message before the error code. If you get a
particularly cryptic one, people here might be able to help. If you' re
really stuck you could also bug me on MSN, I...
