Looks like you just have to set " status" to " enable" before those will
become visible. Keep in mind that all you have to do is set that one
value, you do not need to save/apply the config to see the other
options.
What error message does it give you when it fails? Have you changed the
model line at the top of the config file (all the lines starting with #)
to match the 600C? The easiest way is usually to backup the existing
config on the 600C and selectively c...
Remember to turn off any DNS forwarding as well. If you want a quick way
to check what is using internal try this diagnostic command. Keep in
mind it' s a diagnostic command, so it' s not supported or very user
friendly. diag sys checkused system.int...
Can you post the debug output from dhcpd (on boot and when a discover
comes in)? Can you do a " diagnose sniffer packet any " port 67 or port
68 or arp" 4" ? Perhaps the server is sending the response somewhere it
shouldn' t?