Does anyone have a work-around for the following error? Getting this on
FortiClient EMS server 7.0.0 build 0042, when attempting to create a new
installer.When trying to add, won't go past the 2nd screen: get Error:
Request failed with status code 40...
Has anyone deployed FortiClient 7.0.0.0029? Seems to fix a lot of issues
but hit and miss in upgrading clients from 6.0.10 to 7.0.0 Finding after
upgrade, when users try to launch vpn, clients sits there saying
connecting but never goes past that.Aft...
Has anyone deployed FortiClient 7.0 to endpoints using Fcconfig.exe or
similar method. Prior to 7.0 we were running: "FCConfig.exe" -o export
-f C:\Temp\EMSServer_name.conf With XML file to register the clients
against the EMS server:
fgt_sn0
fgt_...
I'm currently running FortiClient EMS 6.0.8 and planning to upgrade to
6.2.8 then to 6.4.3 The admin guide for 6.4 says: "When upgrading
FortiClient EMS from 6.0 to 6.4.0, EMS retains the 6.0 license after the
upgrade. However, due to the major licen...
Started getting reports from users on ssl vpn saying their connection
gets up to 90% then fails with the error "Unable to reach tunnel gateway
/ policy server"FortiClient version is 6.0.10.0297 Anyone else seeing
this?
Sounds like you need policy based routing.Go to Network| policy routes
Here you can tell the Fortigate to override the routing table and send
traffic to a different interface / next hop address.You also have the
option of configuring policy based rou...
I have had the same issue quite a few times where the slave has upgraded
but the master has not.If you are on site or have someone on site I
would use method1. Means an outage when it reboots but if you find that
the master has some other issue preve...
You should be able to do what you want using the config firewall
local-in-policy If you enter set int ? you will get a list of all
available interfaces that the policy can be applied to. If you just want
to block access from a set of IP's then create...
You may run into problems trying to downgrade the firmware as the master
is already on that firmware.I would say you have two choices: 1.
Shut-down HA2, upgrade HA1 then power-on HA2. This would of course mean
an outage when HA1 reboots to complete t...
Apply policy as below: Create the Local in Policy to restrict access
only to the predefined group on management interface (here: port1):
config firewall local-in-policyedit 1set intf port1set srcaddr
"MGMT_IPs"set dstaddr "all"set action acceptset se...
